Novak Diablo Dual Battery Brushless 550 System.
Novak is proud to introduce an all new brushless system for your twin
battery monster truck-the Diablo Dual Battery Brushless 550 System.
Novak's Diablo brushless system was designed from the ground up to run
from any dual 2S LiPo or dual 6-cell NiMH battery packs intended for
full-sized 10th scale vehicles. Not only is the system a perfect fit for
the Traxxas E-Maxx and other dual pack monster trucks, but it is ultra
simple to operate, and packed full of cutting-edge features.
The Diablo System features the completely new Diablo Dual Battery
Brushless ESC. While it may use the same heat sink and case as other
popular Novak products, the similarities stop there. The internal
components of this speed control are all new, and designed specifically
for the high demands of monster truck bashing and thrashing. Enhanced
thermal protection, updated low-voltage protection, and Novak-Only Motor
ID firmware ensures that the Diablo system will remain safe and sound
as you push your truck to the limit. The perfect ESC requires the
perfect motor, and the Diablo System utilizes the customized Diablo 550
Brushless Sensored Motor. Novak has chosen this special breed of
brushless motor to provide power-hungry monster truck owners with the
best balance of performance, reliability, and runtimes.
Diablo Features:
- Designed specifically for dual-battery pack vehicles such as the Traxxas E-Maxx
- Sensor-based system for excellent torque and low-speed driveability
- Plug-and-Play: Factory-wired with genuine Traxxas battery plugs & gold-plated Bullet motor plugs
- 3 Throttle Modes: Default, Standard, and a Limited Mode (ideal for beginners)
- Novak-developed Bash Boost™ for an extra burst of power at full throttle
- Novak
X-Drive provides enhanced throttle response, ultra smooth power
delivery, higher top speeds, and cooler operating temperatures
- Novak's Launch Limit to minimize battery pack heating and damage, and to maximize run time
- Novak's One-Touch Set-Up for quick and easy transmitter set-up
- Water-resistant case with protective silicone gasketed seal to help keep out the elements
- Smart-Stop Dual LiPo Cut-Off Circuitry independently monitors both battery packs
- Robust 3-amp BEC for strong and fast steering response under any condition
- Thermal Overload Protection circuitry to protect the Diablo ESC and motor from overheating
- Built-in diagnostic temperature monitoring that lets you quickly check the ESC's temperature at any time
- On-board Hall Sensor Test to easily and quickly verify that the motor's sensors are working properly
- Included cooling fan and factory-installed, cross-cut heat sink for cool operation
- On-board power capacitors—no external module
ESC Spec Check:
- Fwd/Brk/Rev
- Input Voltage: Dual 2S LiPo or Dual 6-cell NiMH
- Size: 29.5 x 37.3 x 24.6mm
- Weight (w/o wires): 1.29 oz. (36.6 g) [System Weight: 12.6 oz, 357g]
- On-Resistance: 0.0004 ohms
- Motor Compatibility: Diablo Sensored Brushless Motor only
- BEC 6 Volts / 3.0 Amps
- Wire Size:: 14G Silicone Wire with Traxxas battery and gold-plated Bullet motor plugs factory installed
- Status LEDs: 5 (multi-colored)
Motor Spec Check:
- Design: Sensored
- Size: 35.8 x 72.1mm
- Weight: 10.1 oz. (286.3 g)
- Shaft Diameter: 5mm
- Magnet: One-piece, multi-pole Sintered Neodymium
Please Note: Do not use NiMH batteries
with this Motor/ESC combo. Power consumption is too high and will lead
to random shut downs of the ESC. 
