The Smart Boost 1-Cell Li-Po Step-Up Module allows nearly any brushless
or brushed speed control, receiver and servo to run on 1-cell Li-Po.
This technology expands racing opportunities for many drivers by
reducing racing expenses and giving drivers the chance to race on
smaller tracks.
The Smart Boost increases the 1-cell Li-Po battery pack's voltage from
3.3V - 4.2V to 6V, ensuring that the receiver and servo receive a full
6V/3A power throughout the duration of a run. This allows the
electronics to operate at their optimum levels. Additionally, the Smart
Boost gives you the ability to run a 1-cell Li-Po cell with the same
ESC, servo and receiver that you would normally run with any 2-3S Li-Po
or 4-7 cell NiMH battery pack, including all of NovakΆs brushed or
brushless speed controls.
Not only electrically powered cars can benefit from this technology. The
Smart Boost is also compatible in nitro vehicles. Installed between a
nitro vehicle's 1-cell Li-Po pack and receiver, the Smart Boost can
boost a nitro vehicle's voltage to 6V/3A to power the receiver and
servo.
By increasing battery output voltage, the Smart Boost allows users to
use any radio receiver in single-cell applications, including spread
spectrum radios. The usual voltage fluctuations that cause reception
issues with your radio using 1S Li-Po or 4-cell NiMH battery packs are
no longer a concern.
Features
- Increases a 1-cell Li-Po battery pack's voltage from 3.3V - 4.2V
to 6V, which provides enough power to run almost any ESC, servo and
receiver
- Provides consistent power to vehicleΆs electronics
during entire charge
- Li-Po Cut-Off Circuitry for battery
protection
- On/Off Switch for clean installation and easy
operation
- Universal JST Plug that fits all popular brand
receivers
Spec Check
- Input Voltage: 1S Li-Po
- Output Voltage: 6 Volts
- Output
Current: 3 Amps
- Input Wire Gauge: 20 AWG
- Output Wire
Gauge: 26 AWG
- Size: 1.18” x 1.04” x 0.45” / 30.0 x 26.5 x 11.5
mm
- Weight: 0.48 oz. / 13.50 grams
- LEDs: 1 on-board
