The F-86 Sabre model you have bought is noteworthy by several features:
- It is almost ready to fly. After finishing its assembly you
only need to apply decals, install the ducted fan and your RC
equipment.
- The model is made of polystyrene foam with tougher
external layer, less prone to surface damage. In addition to that the
exposed places are protected by plastic sheathing. Thanks to the ratio
of the in-flight weight and building material's strength the model is
rather sturdy and the risk of its damage in normal operation is minimal.
- During
the design of the model a maximum attention was devoted to the
aerodynamic layout ensuring high aerodynamic lift/drag ratio, and
providing thusly for a surprising range of speeds as well as for a
pleasant flight behaviour, typical of much larger models.
- To
control the F-86 model a normal RC set for controlling slow-flyers is
sufficient - it is possible to fly most of the aerobatics figures (with
exception of those needing rudder control to execute).
Hollow molded foam construction with a toughened
external layer to resist dings. Ground contact areas are covered in
plastic for wear. Wing is removable for transport and access to the
ducted fan unit. Ailerons are pre-hinged and pushrods come
pre-installed. Fuselage is one piece with internal ducting pre-done.
Battery access is through canopy hatch. Includes waterslide decals for
five versions and glue. Controls are Aileron, Elevator and Throttle.
Technical data:
- Wingspan: 750 mm
- Length: 755 mm
- Wing area: 13 dm2
- Propulsion: Fan unit for Speed 300/6V (Motor Not Included)
- Weight: Max. 480g
- Controlled functions: Elevator, Ailerons, Motor (Radio not included)