V8R7-SP improves the smoothness of high-speed digital servos.
2. Bind Procedure:
1) Turn on your transmitter and switch it to PPM mode, turn off the TX.
2)
Turn on your transmitter while holding the programming button. Release
it a few seconds later. The RED LED on the transmitter module will
flash, indicating the transmitter is ready to bind the receiver.
3)
Connect the battery to the receiver while holding the receiverΆs F/S
button. The LED on the receiver will flash, indicating the binding
process is complete. Turn off the transmitter and receiver.
4) Turn
on your transmitter. Connect the battery to the receiver when ORANGE LED
on TX is on. The LED on the receiver will indicate the receiver is
receiving commands from the transmitter. In a few seconds system is
ready to work (communication is established).
Binding is required
only to set up a new link (like new or additional receiver or
transmitter module). To control multi-receivers, every receiver should
be programmed with the transmitter in binding state.
3. Failsafe:
V8R7-SP supports failsafe function for all channels. Just do it as bellow:
After
the receiver has been bind, press briefly the F/S button of the
receiver, the GREEN LED of the receiver will flash twice, the failsafe
is set up successfully.
If you do not need the failsafe function any more, just re-bind the receiver.
Warning: DO NOT connect servos to channel 8, otherwise servos will get hot or even burn out.