Absima presents their new 4WD 1:10 Buggy range. With the AB1 you
finally get what you want; a high quality and robust model sport
beginners Buggy in 1:10 scale. A waterproof 40A ESC and a 15 turns
brushed motor bring the buggy into high gear. Together with the included
NiMH racing pack battery and the charger, we make an all inclusive
package.
Immediately striking is the extremely robust construction of the AT1
chassis. The upper deck (Chassis stiffening middle), as well as the
shock towers front and rear, are made of aluminum. All plastic parts
are made extra strong and have the necessary flex. The reliable 4WD
drivetrain is well prepared for difficult ground and the whole model is
equipped with ball bearings.
Both the ESC and steering servo are water resistant and the recevier sits in a sealed water proof receiver box.
Please use only 2S (2 cells; 7.4V) LiPo batteries with a C-rate of
30C or lower. If you use a LiPo with higher C-rate, the motor could be
damaged. NiMH (max. 7.2C; 6 cells) batteries could be used any type
without exception.
Equipment:
Complete built
Ball bearing transmission
Adjustable oil shocks
CVD steel shafts
Powerfull 550 15T motor with heat sink
Waterresistant speed controller
Waterresistant steering servo
Gear differentials front & rear
Aluminum engine mount
Complete covered transmission
CVD steel shafts on front axle
Complete adjustable turnbuckles
Aluminum upper deck
Aluminum brace mount front & rear
Servo saver
Printed body
Charger and NiMH Racing Pack included
Technical specifications:
Length: 430mm
Width: 270mm
Height: 140mm
Weight: 1580g
Wheelbase: 293mm
Chassis clearance: 25mm
Speed: +40 KM/H
