Milliput Black.
- Can be manipulated like modelling clay
- For restoration of ebonised wood, antique clocks and cast iron
- For restoration of porcelain and other ceramics, slate, marble...
- For sculpting and modelling
- Goes rock hard in 2-3 hours at room temperature
- Heat resisting 130 degrees C
- Two part, cold setting, epoxy putty
Product Description
Milliput is the trade name for our epoxy putty.
Milliput produce five grades: Standard Yellow/Grey, Silver Grey,
Superfine White, Terracotta, and the latest addition - Milliput Black.
Each grade is presented in similar packs containing 2 x 56á7gm. sticks
and the general instructions for preparation and usage are the same.The
two sticks have a long shelf life but once mixed the resultant putty is
at first soft and highly adhesive and then gradually hardens. Speed of
hardening is dependant on temperature and at normal temperatures
(20-25_C) Milliput becomes rock hard in three to four hours. By the
application of heat the setting time can be reduced to a few
minutes.After setting hard Milliput continues to cure and is fully cured
after an elapse of time equal to the setting time at the same
temperature. Once fully cured Milliput can be machined, drilled, tapped,
turned, filed, sawn, sandpapered and painted. Milliput can be
sandpapered and painted immediately it has set. (it is advisable to wear
eye protection during this process).Milliput is an excellent adhesive
and will bond any of the following to itself or to any of the others -
wood, brick, cement, metals, concrete, plastics, glass etc, but note
that Milliput is not intended as a thin layer adhesive and should not be
used where a paste, mucilage or thin glue is indicated. Milliput will
set under water and is heat resistant up to 130°C.Shelf Life:We
recommend Milliput is stored in cool, dry conditions. Please reseal bags
after use. Stored correctly this product should remain workable for
about 2 years.
A Cool Tip!
If you are interrupted while
you are mixing Milliput, you can put the Milliput into a deep freezer
until you can get back to work. This will keep the product at
approximately the same state of setting at which it was frozen for up to
36 hours. Simply remove the now frozen product from the freezer and
warm in the hand and it is ready to use. If stored immediately on mixing
it retains its sticky nature.